Umair Ramzan 
If you’re new to longboarding or have been riding for a while, you may be wondering how to turn sharply. It’s not as simple as just leaning in the direction you want – if you do that, you’ll likely end up going straight off the road!
It would be best if you did a few things to make a sharp turn on your longboard.
- First, you must shift your weight to the front of the board. This will help the board pivot around the trucks.
- Next, lean into the turn and use your back foot to push off the ground, which will help the board rotate.
- Finally, keep your body low and close to the board’s deck – this will help you maintain your balance and control as you make the turn.
With these tips in mind, practice turning in both directions to master the technique. Then, take to the streets and show off your newly-acquired skills.
How to shift your weight?
For all the fun, adventure, and sheer enjoyment you’ve had on your longboard, you’ll have to know how to shift your weight properly when you’re on your longboard. Learning how to shift your weight is a key skill for learning how to turn on a longboard. There are two ways to shift your weight on a longboard.
The first way is to lean your body weight back by squatting down. The second way is to move your foot back. One of the most important things to remember when you are learning how to turn on a longboard is that you need to be in a balanced position before you even think about trying to turn. If you start with one foot in front of the other, you will have a tough time turning.
How to make sure you don’t fall?
Longboards are versatile equipment that can be used for many things. If you are new to riding one, there are a lot of tricks and tips you need to know. One of the most important things to remember is to ensure you don’t fall.
If you fall off your longboard, you’ll have more difficulty controlling it again. If you are going to turn sharply, you need to make sure that you are turning the board, not your body. To make the turn, you must lean your body off the longboard and use your arms to hold yourself in place. You can also use your foot straps to help maintain your balance.
How to push off the ground?
There are many ways to push off the ground on a longboard, but the most common is to push off the heel of your foot. Pushing off the heel of your foot puts your weight over the back wheel, allowing you to accelerate quickly.
However, when you are turning sharply, it doesn’t always let you get traction. In this case, you can use your front foot to push against the ground. You can also use your back foot to push into the ground if you want more control.
Conclusion
We hope you enjoy our blog post on how to turn sharply on a longboard! One of the biggest mistakes that first-time longboarders make is suddenly changing direction without making their board go where they need it to go. If you want your board to go where you want it to, you need to be able to make sharp turns.
Our blog post is full of tips for beginners and experienced longboarders alike on making sharp turns. Don’t hesitate to contact us anytime if you have further questions or comments! We would be excited to hear from you!
FAQs
How do you make sharp turns on a longboard?
You can make a sharp turn if you lean into the turn and use your outside foot as a brake. The inside foot is for pushing off.
How do I turn tighter on longboard?
You can make a sharp turn if you lean into the turn and use your outside foot as a brake. The inside foot is for pushing off.
Is a longboard easier to turn?
Generally speaking, longboards are more accessible to turn than shortboards.
Why is it hard to turn on my skateboard?
It is hard to turn because you are going too fast, and the board has a rounded edge, which makes it difficult to turn.
Why does my longboard wobble at high speeds?
Your longboard could suffer from a lack of balance that causes the wheels to wobble as you ride. This is caused by either or both wheels having too much weight on them. You can solve this issue by checking your balancing weight distribution on your longboard and changing it if necessary.
